Cables Unlimited Headphones SPK SHOWER User Manual

SPK-SHOWER  
showerPOD 900MHz Wireless Shower Speaker  
USER MANUAL  
 
Parts Identification  
Transmitter  
Receiver  
Adapter  
 
Transmitter Operation  
1. Plug the included AC adapter into a standard wall outlet  
2. Turn on the power switch on rear transmitter. A blue indicator flashes  
when the AC adapter is plugged in. If the blue POWER indicator does  
not illuminate, ensure the adapter is plugged in.  
3. Insert the adapter connector plug firmly into the DC jack located at the  
back of the transmitter  
4. You can pull out a 3.5mm audio cable in front of the transmitter, which  
you can connect it to the i-pod’s output jack. After used, just pull it for a  
bit and release, then it will roll back automatically  
5. The rubber surface of the transmitter is specially designed for you to lay  
your I-pod on it to prevent sliding down  
6. You can also connect the 3.5mm audio cable to the other end to the  
output jack of any of your desired audio sources, like MP3, CD, DVD,  
TV, Radio recorder, etc.  
7. When an audio signal reaches the transmitter, the Blue indicator  
illuminates steady. If the Blue indicator keeps flashing, ensure the audio  
source is switched on  
Speaker  
Battery Operation  
1. To operate the speaker using battery power, open the battery  
compartment cover located at the rear of the speaker  
2. Insert six AA size batteries (purchase separately) into the battery  
compartment, observing proper +/- polarities as indicated  
3. Replace the battery compartment cover  
 
AC Operation  
1. To operate the speaker using AC power, plug the 9V power adapter into  
a standard wall outlet  
2. To insert the power adapter connector plugs firmly into the DC IN jacks  
located underneath the speaker  
Speaker Operation  
1. To switch on the speaker, press the POWER button located on the front  
panel of the speaker. A blue power LED on the speaker illuminates  
2. To listen to a desired audio source through the speaker, switch on the  
audio device that the transmitter base is connected to. The blue LED on  
the transmitter illuminates steady  
3. Depending on location, select CHANNEL 1 or 2 on the transmitter base  
for optimal performance  
4. To locate the strongest operating frequency, press the AUTO TUNE  
button located on the front speaker panel. When the Auto Tune function  
is engaged, frequency scanning begins automatically and stops when a  
signal is detected.  
5. You should experience interference-free speaker reception during  
normal room to room operation. If interference or poor signal reception  
occurs, press the AUTO TUNE button located on the speaker once (the  
blue LED indicator illuminates) to locate the strongest operating  
frequency.  
6. If peak reception remains elusive, switch the CHANNEL setting (1 or 2)  
on the transmitter base, then press the AUTO TUNE button on the  
speaker to locate the corresponding frequency  
7. “The BASS BOOST button can be used to enhance the bass sound  
depending on your music preferences. Turn bass / boost effect ON  
simply by pressing the button down on the speaker, and pressing it  
once again to turn it OFF.“  
8. To suit the needs of different users, you can mount the speaker inside  
your bathroom  
 
Speaker Operation  
Note:  
When transmitting over long distances, the audio signal becomes weaker  
and interference increases.  
If the source signal is too weak for reception, the transmitter automatically  
switches off, blue indicator will flash after approximately four minutes to  
protect the unit and save power. If the source signal returns to an adequate  
level, the transmitter automatically switches back on.  
Power Off  
To switch off power, press the ON/OFF button on the front panel of the  
speaker. And then slide power switch to “OFF” position at rear transmitter.  
Volume Control  
To adjust speaker sound level, press the +/- buttons located on the front  
panel of speaker until the desired volume is reached.  
This device must be used with the AC/DC adapter supplied in the  
package.  
Troubleshooting  
No Sound  
-
Ensure the AC adapter is securely plugged into the wall outlet and the  
transmitter DC IN jack  
-
-
Ensure the speaker POWER button is in the ON position  
Speaker batteries may be too weak. Replace with new batteries or connect  
with the AC/DC adapter (Included)  
 
-
-
Ensure the connected audio device is switched on and producing a signal.  
Ensure that the volume level is set to a moderate level  
Distortion  
-
-
-
Ensure the speaker and transmitter are operating on the same frequency. If  
not, press the AUTO TUNE button until both units are operating on the  
same frequency  
Switch the CHANNEL selector position (1 or 2) on the transmitter base and  
press the AUTO TUNE button the speaker until the matching frequency is  
reached  
Speaker batteries may be too weak. Replace with new batteries or connect  
with the AC/DC adapter (not supplied)  
-
-
Ensure that the volume level is set to a moderate level  
The audio signal input level is too low. Increase the volume level of the  
audio source  
Specifications  
Transmission Mode: UHF mono  
Carrier Frequency: 900MHz Digital Hybrid  
Operation Voltage: Transmitter, DC 12V 200mA adapter  
Speaker, 6 x AA batteries (not supplied) or DC 9V 500mA  
adapter (included)  
Frequency Response: 40Hz - 12KHz  
Distortion: 1%  
S/N Ratio: 70dB  
Operating Distance: Up to 150 feet  
Package includes:  
Wireless shower speaker x 1  
Audio transmitter x 1  
AC/DC power adapters x 2  
6.3mm to 3.5mm stereo adapter x 1  
User manual x 1  
ATTENTION:  
The transmitter for this speaker set is designed to work with a wide  
variety of devices. Our tests have shown the default volume levels of  
iPods, MP3 players and other devices connected to the transmitter  
 
through the headphone jack does not have the signal strength required  
by the transmitter. Raising the volume of your device will increase the  
signal strength to the transmitter. The blue signal LED will light when the  
required signal strength from your device is reached. We recommend  
that you keep the volume set on your iPod or MP3 player at a minimum of  
¾ of full volume.  
 

Black Decker Fryer SKG110C User Manual
Blue Rhino Outdoor Kitchen Island GBC873W C User Manual
Bogen Amplified Phone AH5A User Manual
Bosch Appliances Clothes Dryer WTMC 3500UC User Manual
Bosch Power Tools Cordless Drill PS40 2 User Manual
Bose MP3 Docking Station SoundDock Series III User Manual
Canon Computer Accessories PGI 5 User Manual
Canon Photo Printer MP550 User Manual
Cateye Bicycle Accessories HL RC220 User Manual
Cisco Systems Conference Phone 7937 User Manual