Failure to follow these warnin
instructions could result in se
Highchair
OWNER’S
MANUAL
Model No. _______
Serial No. ________
Dear Customer,
Please fill in the
model and serial
numbers above
from the label on
the back of the
footrest of your
new highchair.
Prevent serious injury or death from
falls or sliding out. Always secure
child in the restraint.
Models 3630 and 3635
Congratulations on your purchase
of a Graco® highchair!
Graco is the recognized leader in the
design and manufacture of quality baby
products. We believe your new Graco®
highchair is a wise choice, promising many
hours of enjoyment for your baby.
Before using your highchair, please take a
few minutes to read this Owner’s Manual.
The short time you spend reading these
instructions will help you to use your
highchair properly.
NEVER LEAVE YOUR CHILD
UNATTENDED. Always keep
your child in view.
S
D
w
b
Please save your Owner’s Manual
for future use.
FOLLOW ASSEMBLY INSTRUCTIONS CAREFULLY.
If you experience any difficulties, please contact the
Customer Service Department.
Customer Satisfaction
FR
loo
th
Our goal is to make every product the best it
can be! We are also committed to supporting our
products after purchase. If you would like to speak
to Graco about your product, please contact our
Customer Service Department at 1-800-345-4109
Our knowledgeable staff will be ready to answer
any questions you may have concerning parts,
use, or maintenance. When you call, please have
the model and serial numbers ready so your
call may be processed quickly and efficiently.
THIS HIGHCHAIR IS DESIGNED TO BE USED by a child
up to 3 years of age. Maximum weight 37 pounds (17 kg).
TO
or
DO NOT FORCE TRAY against child. Use only the five
adjustment positions. Be sure both adjustment fingers are
engaged in armrest slots.
DO NOT ADJUST the highchair with your child in it.
DISCONTINUE USING YOUR HIGHCHAIR should it
become damaged or broken.
© 1999 Graco 231-3-99 IS3548
2
PARTS LIST
e warnings and the assembly
sult in serious injury or death.
CHECK that you have all the parts listed
below BEFORE assembling your highchair.
If any parts are missing,
call Customer Service at 1-800-345-4109 or visit
Secure your child at all
times with the restraint
system provided, in either
the reclining or upright
position. The tray is not
designed to hold your child
in the highchair.
Tools required: Screwdriver
It is recommended that the
highchair be used in the
upright position only by
children capable of sitting
upright unassisted.
Seat with seat belt
Seat pad
OR 5-point harness
death from
s secure
Support tube
Tray
T-nut (2)
Bolt (2)
Screw (4)
Recline bar
STRANGULATION HAZARD:
Upper tube
Foot (4)
DO NOT place highchair in any location
where there are cords, such as window
blind cords, drapes, phone cords, etc.
Recline
bracket (2)
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR HIGHCHAIR for
loose screws, worn parts or torn material. Replace or repair
d
the parts as needed. Use only Graco® replacement parts.
TO CLEAN HIGHCHAIR FRAME, use only household soap
or detergent and warm water. NO BLEACH.
Rear tube
Front tube
3
4
5-POINT HARNESS MODELS (For waist belt models, see next section.)
To Attach Seat Pad
To Secure Your Child
Prevent serious injury or death from
falls or sliding out. Always secure your child in the
restraint. Do not depend on the tray alone to hold
your child.
Step 1.
Straps must be removed
from seat before pad can be
attached. Behind the seat
back, locate four plastic
retainers on shoulder and
waist straps. Push them
through the slots to the
front and set straps aside.
Step 1.
Step 2.
Place your child’s arms
through the loops created
by the shoulder/waist
straps and insert the
harness buckles into the
center buckle housing.
Place seat pad over highchair.
Step 3.
Push each retainer back
through proper hole in rear of
seat. Two levels of shoulder
holes are provided; choose the
level that is at or slightly above
your child’s shoulders.
Step 2.
Adjust the shoulder and crotch
strap lengths as needed to get
a snug fit around your child:
Avoid twisting straps.
!
To tighten shoulder straps,
Step 4.
hold free end of strap and
slide adjuster away from the
free end.
Pull crotch strap and buckle
through center opening in seat
pad.
Step 5.
!
To loosen shoulder straps,
hold adjuster and pull strap
back through the adjuster.
Attach seat pad by sliding
pocket over the back of the
seat as shown. Then hook
sides of pad over the two tabs
on each side of the highchair.
Tabs
Step 3.
Finish by giving a quick tug on
the free end until shoulder straps
are tight.
Step 6.
Push the two tabs on the
bottom of the seat pad into the
two slots in the bottom of the
seat as shown.
Check behind and in front of
seat to see that belt is tightly
threaded through retainers and straps are tight.
From the rear of the footrest,
pull the two tabs over the plastic
anchors near them.
The position of the shoulder straps can be adjusted for
the size of your child. Locate the two plastic retainers
behind the seat back, push them through to the front
and move them to the higher or lower position as
desired.
If it later becomes necessary to launder or replace the
harness, follow the directions above to remove harness
straps from highchair.
7
8
Step 2.
WAIST BELT MODELS
(For 5-point harness models, see preceding section.)
To
Pull other end of the seat belt
through the belt retainer as shown.
ad
yo
To Attach Seat Pad
Step 3.
Step 1.
To rethread buckle, reverse the above steps. CHECK that
the belt is threaded correctly by pulling on the seat belt.
The belt should not slip through the buckle.
Ad
Ho
an
fir
he
Sl
th
de
W
Attach seat pad by sliding
pocket over the back of the
seat as shown. Then hook
sides of pad over the two
tabs on each side of the
To Use Tray
Tabs
highchair.
Place tray on armrests of seat.
Pull out side handles under the
tray. Put tray in one of the five
adjustment positions, and
release side handles.
be
aw
ad
Step 2.
Pull the seat belt through the
hole in the middle of the seat
pad.
Th
he
ca
by
he
CHECK that tray is securely
attached by pulling forward
on the tray.
Push on
front button
Use either the side handles
or the front button to adjust or
remove the tray.
Step 3.
CH
ch
de
no
Push the two tabs on the
bottom of the seat pad into the
two slots in the bottom of the
seat as shown.
DO NOT force
the tray against your child.
Keep your child’s hands and
fingers away from the tray
when adjusting the tray.
From the rear of the footrest,
pull the two tabs over the
plastic anchors near them.
To
La
sh
m
To Adjust Recline
To Secure Your Child
DO NOT adjust
the highchair with your child
in it.
pla
re
hig
Snap buckle together as
shown. Adjust belt as needed
to get a snug fit around your
child.
Pull up on the recline bar at
back of seat to release the
seat. Then pull or push seat
to the desired recline position.
To release, squeeze buckle
at sides.
After adjusting recline, push
down on recline bar to lock
seat.
Seat can be adjusted to three
different recline positions.
If it becomes necessary to remove the seat belt for
cleaning or replacement, follow these instructions:
CHECK that both sides of the
chair are snapped into the
desired recline notches.
Step 1.
Do not use tray when seat is
in a recline position.
Remove seat pad. Unthread end
of seat belt through the buckle as
shown.
231-3-99 IS3549
9
10
Replacement Parts
To Adjust Height
Instructions for ordering highchair parts:
DO NOT
adjust the highchair with
your child in it.
Complete form below. Your highchair model number
MUST be included on the form to ensure proper
replacement parts. Your model number can be found
on a sticker on the back of the footrest. Payment
must accompany your order.
Pull UP
Adjust seat to upright position.
Hold chair frame down
and lift top of plastic seat
firmly to free pegs from
height-adjustment notch.
Slide seat up or down in
the track, then snap it into
desired height setting.
When adjusting height,
be careful to keep fingers
away from the height-
adjustment track.
Parts List:*
Price:**
Seat.................................... $22.00
Seat pad............................. $13.00
Seat belt*............................ $ 5.00
Harness*............................. $ 5.00
Tray..................................... $19.00
Support tube....................... $ 7.00
Rear tube............................$10.50
Front tube........................... $10.00
Upper tube..........................$ 9.50
Recline bracket (2)............. $ 7.00
Recline bar..........................$ 5.00
Foot (each)......................... $ 5.00
Hardware.............................$ 5.00
There are five possible
height settings. The highchair
can be used as a toddler chair
by adjusting to the lower
height settings.
* On certain models only.
** Prices subject to change without notice.
IF YOU NEED HELP
If you have any questions or if you need any part
not listed, please call toll-free:
CHECK that both sides of
chair are snapped into the
desired height-adjustment
notch.
1-800-345-4109
Return the form below with payment to:
GRACO CHILDREN’S PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
To Fold Highchair
ELVERSON, PA 19520
Lay highchair on the floor as
shown. Press in and hold the
metal buttons at base of both
plastic brackets, then push
rear leg tube down to fold
highchair.
Model Number SHIP TO:
(Must be filled in)
Name
Seat
Seat pad
Seat belt
Harness
Address
City, State, Zip
Tray
Support tube
Rear tube
Front tube
Upper tube
Recline bracket
Recline bar
Foot
(
)
Telephone
Check enclosed
(payable to Graco Children’s
Products Inc.)
Hardware
Charge to credit card:
Visa
MasterCard
Discover
Total:
Shipping
& handling:
$5.00
Account #:
6% sales tax
(PA only):
Expiration date:
Signature:
Total amount
due:
11
12
|