INSTALL INSTRUCTIONS C-TCB-30
2000-2005 CHEVROLET IMPALA
TOOLS REQUIRED:
Ratcheting Wrench
Torx Bit Set
Standard Wrench Set
Screwdriver Set
Standard Socket Set
HARDWARE:
QTY DESCRIPTION
PART #
7
7
7
1
2
1
¼-20 x ¾” Hex Head Bolts
¼” Flat Washers
¼” Lock Washers
5/16-18 x 1” Hex Head Bolt
5/16” Flat Washers
5/16-18 Nylock Nut
GSM33001
GSM31005
GSM31026
GSM33012
GSM31006
GSM30017
MAIN COMPONENTS:
QTY DESCRIPTION
Main Seat Base Plate
Telescoping
Pole
1
1
1
1
Main Seat Base Plate
Pole Support Assembly
Cross Brace
Pole Support
Assembly
Telescoping Pole
Cross Brace
SUB ASSEMBLY:
1. Remove Passenger Seat:
• Remove (2) T-50 torx bolts on passenger seat base.
• Disconnect wire plug if vehicle has power seats.
• Remove head rest on passenger seat.
• Angle seat forward and pull back to remove seat, which is held down in the front by
(2) hooks on the floor.
INSTALLATION:
1. Mount C-TCB-30:
• Position Main Seat Base Plate so that square cutouts are positioned where hooks for
seat are located.
• Replace passenger seat sliding hooks into the floor first.
• Replace torx bolts (T-50).
• Mount Pole Support Assembly to Main Seat Base Plate using ¼-20 x ¾” Hex Head
Bolts, Washers and Nuts.
• Attach Cross Brace to Pole Support Assembly using Tab on side of pole and
5/16-18 x 1” Hex Head Bolt, Washers and Nuts.
• Mount Cross Brace on passenger seat using existing hole.
C-TCB-30-INST-9-05
|